In the Executive Block I've found an option to stop simulation at the end of a certain count. I've set that to the number of exits. I also see under Simulation setup that I can make the simulation run for X number of minutes.
I'd actually like the sim to stop after 100 runs. But it seems to keep running unit it hits the time set in simulation setup. I see this from my plotter.
How can I get it to stop at 100?
Count Connector vs End Time
Re: Count Connector vs End Time
It sounds like what you have done should work. I have attached a model that stops when the 100th item exits
- Attachments
-
- End after 100 items processed.mox
- Simulation stops when 100th item exits
- (327.74 KiB) Downloaded 573 times
-
Simstarter1
- Posts: 9
- Joined: Fri Nov 20, 2015 12:21 pm
Re: Count Connector vs End Time
Hi Dave,
It says your file was created in a newer version of extendsim so I can't open. Would you mind saving it in an older version or explaining what you did?
It says your file was created in a newer version of extendsim so I can't open. Would you mind saving it in an older version or explaining what you did?
Re: Count Connector vs End Time
Sorry, I only have ExtendSim 9.2 and 9.1 (which are the same file format). I recommend that you upgrade. I connected the output of the Exit block to the count input on the Executive.
Dave
Dave